Search the forum,

Sirrus TS1503 cold on start

Post new thread

Discuss Sirrus TS1503 cold on start in the Bathrooms, Showers and Wetrooms area at PlumbersForums.net

P

Plipplop

Messages
22
I do hope you can help, I have a Sirrus TS1503 shower connected to a combi boiler. Sometimes, not all the time, the shower will be cold to start with and stays that way. if you leave a while and then try again it will be OK warm/hot does not get cold when in use, and temperature is very controllable. Do you think this is a cartridge problem, or do you think servicing the cartridge would cure this startup problem. The reason I ask is cos when working all control of temp etc. is all ok. Your help would be genuinely appreciated
 

Reply to Sirrus TS1503 cold on start in the Bathrooms, Showers and Wetrooms area at PlumbersForums.net

Similar plumbing topics

P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
339
Chuck
C
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
231
DIwhYdidIstartThis
D
johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
251
exedon2
exedon2
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
189
dreikher
dreikher
D
Covering shallow sewer pipe under concrete Patio
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
243
DIwhYdidIstartThis
D
Creating content since 2001. Untold Media.

Newest Plumbing Threads

BS 5389 Tiling Standards
Tilers Forum
Tiling Forum UK
British Standards in Tiling BS5389
Electrical Advice | Electricians Blog
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock