Search the forum,

New member saying hi to everyone on the UK plumbers forum

Post new thread

Discuss New member saying hi to everyone on the UK plumbers forum in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
1

1DavidBrown

Hi everyone,

New member saying hi to everyone on the UK plumbers forum

David Brown:coolgleamA:
 
hello and welcome
 
Welcome
Aston Fan ?
My apologies if it's your real name ( you must get sick of it )
 
Welcome
Aston Fan ?
My apologies if it's your real name ( you must get sick of it )
 
Sorry for Double post, happening all the time at the mo, Forum slow too
 
Status
Not open for further replies.

Reply to New member saying hi to everyone on the UK plumbers forum in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
311
oz-plumber
O
P
LCS to new water mains
Hi, I have an old steel water mains pipe (approx 45mm) that I need to connect to a new pehd water mains (25mm). I can't get at it to create a new thread so what's the best way of connecting the two? Cheers, Peter
Replies
2
Views
219
ShaunCorbs
ShaunCorbs
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
372
Timmy D
T
B
What is correct toilet supply line
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
198
ShaunCorbs
ShaunCorbs
D
UK Can't get stopcock 100% closed to allow a tap repair
I have a plumber coming tomorrow to change a cartridge on a badly dripping tap on my bathroom mixer unit. There is no separate isolating valve for this tap so I'll have to close the stopcock. I tried closing it today but it won't go absolutely 100% closed and there is still a very slight flow...
Replies
1
Views
255
Chuck
C
Creating content since 2001. Untold Media.

Newest Plumbing Threads

UK Tiling Forum
Plumbing Advice
Contractor Advice Forum
Tiling Advice
Tiling Forum UK
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock