Search the forum,

Discuss leaky radiator tapping in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
A

ajoint

whats the quickest eand easiest way to sort out a leaky rad tapping witout changing the system down?also i have a control valve on one side of the rad ,i turned with the pump pliers and its leaking water?i turned it because radiator is not getting hot as system been recently piped up.thanks,ajoint.
 
post some pictures.

its likely theres not enough ptfe tape on the radiator tail going into the tapping, this can be done by turning off both side of the rad, draining into a tub untill empty and then attend to the offending leak.

the other leak on the rad valve sounds like the gland needs a turn to tighten it up.

pictures will help.
 
thanks for that a wheating,what is was was the locksheild valve tightened it up on the outer screw which stoped the water leaking,nowi have a banging noise in the pipes in one radiator,what can that be?air in the pipes perhaps.
 
If the system has been recently piped as you say I would suggest you call the offending idiot who did the job for you and ask them to clip the pipes ***This is my pet HATE*** No offence is meant...
 
Status
Not open for further replies.

Reply to leaky radiator tapping in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
2
Views
236
P
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
166
Hi bit of a weird issue, I installed a grohe bathroom tap successfully 2 months ago bought from screwfix. Last week the right hand hot tap makes a squeak noise as I turn it on or off, left tap is 100% perfect and noiseless. This grohe tap is like one unit, so no screw notch or way I can remove...
Replies
7
Views
300
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
383
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
248
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock