Discuss Installing a new coil in a 200lt galvanized cylinder in the USA area at PlumbersForums.net
The coil is obviously corroded so I intend to put a new indirect coil and install it in a similar way as in the attached photo and to plug off the existing indirect connections
What I need is where to locate Essex type flanges in large size to adapt to the cylinder which is about 2mt high and 75cms wide galvanized
The reason not to change the cylinder is that it was installed during construction and is very difficult to exchange without huge pipework and brickwork alterations.
Impossible to put into a lift and limited room in stairs (5th floor)
What I need is where to locate Essex type flanges in large size to adapt to the cylinder which is about 2mt high and 75cms wide galvanized
The reason not to change the cylinder is that it was installed during construction and is very difficult to exchange without huge pipework and brickwork alterations.
Impossible to put into a lift and limited room in stairs (5th floor)
Attachments
Last edited:
Reply to Installing a new coil in a 200lt galvanized cylinder in the USA area at PlumbersForums.net
Similar plumbing topics
Hi,
My current hot water system needs to be replaced.
Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't...
Hello all,
I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to...
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about...
Hi all,
I'm installing a concrete patio out back. By the wall under the kitchen sink I have an existing P-Trap gully for the grey water from the...
Hello all,
I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m...
Creating content since 2001. Untold Media.