Hi All, I have this monobloc basin mixer tap in my bathroom. It was installed 11 years ago, but the hot valve has started to drip from the top around the tap head. Problem is I don’t know how to get to the valve. There are no grub screws visible and I’ve tried to remove the valve cover but it won’t turn. Any ideas? Thanks.
Discuss Help! Tap Valve Removal in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net
Hi All, I have this monobloc basin mixer tap in my bathroom. It was installed 11 years ago, but the hot valve has started to drip from the top around the tap head. Problem is I don’t know how to get to the valve. There are no grub screws visible and I’ve tried to remove the valve cover but it won’t turn. Any ideas? Thanks.
Reply to Help! Tap Valve Removal in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net
Similar plumbing topics
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
I have a plumber coming tomorrow to change a cartridge on a badly dripping tap on my bathroom mixer unit. There is no separate isolating valve for this tap so I'll have to close the stopcock. I tried closing it today but it won't go absolutely 100% closed and there is still a very slight flow...
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Hi all I'm hoping someone can shine a light on this for me
Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall)
Unfortunately turning this to the closed position only reduces...
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
Running copper pipework above / across a Gas boiler?
- Started by kristeva
- Replies: 2
-
Installing pipework to avoid airlocks
- Started by Matt0029
- Replies: 1
-
DUK Pipes for thermostat shower fitted at different heights
- Started by Delforkids
- Replies: 2
-
-
-
SPorcelanosa KRION Attica screen 1.2m, anyone?
- Started by Sebastian T
- Replies: 0
-
Cistern filling one third of the way
- Started by dwaindigital
- Replies: 3
-
Boiler losing pressure only on central heating- Started by SnosRap75
- Replies: 6
-
tanking. Is it ok to just seal everything with plastic.
- Started by Staggersandfalls
- Replies: 3
-
Pop quiz, does anyone recognise this radiator valve?
- Started by dimuc
- Replies: 4
-
SUsing coil to clear pipe leading to gutter
- Started by Sonya K
- Replies: 2
-
Replacing outdoor P-Trap Gully with Bottle Gully
- Started by DIwhYdidIstartThis
- Replies: 0
-
-
-