Discuss Heatrae Sadia Multipoint 10 Overheating water in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
M

msw109

Water from the tap that this feeds is scalding hot. I've checked the Aquasystem 2 litre expansion vessel that's associated with it and there's no pressure in it. The safety valves seem ok. Would this lack of pressure in the expansion vessel cause the water to become extremely hot?
 
Status
Not open for further replies.

Reply to Heatrae Sadia Multipoint 10 Overheating water in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Looking for any ideas to help. I've a Heatrae Sadia Hot Water tank, heated through Oil fired boiler (working fine). A week ago I reset the air...
Replies
8
Views
374
hello we have an unvented system. we have an issue where the hot water is hot for 10 seconds and then luke warm, turn off taps / wait and turn...
Replies
5
Views
741
Hello, I live in a two floor semi with a gravity fed conventional gas fired boiler (Potterton Kingfisher MF). The boiler is fed cold water from...
Replies
0
Views
528
Hello, I'd love some advice on my system, I've had a couple of plumbers come in that seemed to specialise in gas systems and seemed perplexed by...
Replies
3
Views
988
Hi, I'm looking for a water pump to pump water from a storage tank at a constant 3 bar pressure. It's at a campsite I run that's at the bottom of...
Replies
2
Views
183
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock