You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
multipoint
In telecommunications, point-to-multipoint communication (P2MP, PTMP or PMP) is communication which is accomplished via a distinct type of one-to-many connection, providing multiple paths from a single location to multiple locations.Point-to-multipoint telecommunications is typically used in wireless Internet and IP telephony via gigahertz radio frequencies. P2MP systems have been designed with and without a return channel from the multiple receivers. A central antenna or antenna array broadcasts to several receiving antennas and the system uses a form of time-division multiplexing to allow for the return channel traffic.
Hi all:) This is my first post here.
My Dad recently had an Ariston Next Evo X SFT 16L multipoint water heater installed to replace the previous one that was leaking.
What concerns me is that it basically takes about one and a half minutes for the water to reach even a a basic useful...
Hi,
Looking for a G3 qualified and experienced plumber to take a look at one of our Heatrae Sadia multipoint 50 units sited above ceiling in office toilets,we have an issue were there is constant running water through the tundish.
B31 area.
cheers
Customer has a Main Multipoint BF that needs the diaphragm replacing. I'm attempting to remove the water valve but one of the screws that fix it to the bottom of the gas valve just won't budge. The head of the screw is completely stripped. My trusty neji-saurus screw pliers turned it about 45...
Hi,
Customer has a Main Multipoint Balanced Flue water heater.
Both the gas rate and burner pressure are under what the MIs state. MI state burner pressure is pre factory set at 14.1mbar and should not need adjusting and my checks showed burner pressure as 6mbar. Gas rate MI state 2.9 m3/hr...
Hello All
Problem with the above named water heater.
Red light comes on every 4-5 secs. No hot water operation. When you reset the heater the green light comes on briefly and then the red light starts doing it’s thing?????
Any ideas ?
We have a Corvec Brittony II multipoint that will only ignite the main burners if the temperature control knob on the front of the multipoint is turned up to its maximum heat setting - making the water too hot to use. Do you know what the problem could be?
Hi chaps. Does anyone know of another brand of 15L multipoint electric water heater compared to heatrae sadia. The price for one of These is £600. I need it to do 2 coffee shop sinks and 2 toilet basins. The old unit which is the above is knackered and a company want 1200 to fit new one.
Cheers
Hello,
Hopefully this is the right place to post this.
I have had this water heater for about 20 years and it developed a leak. The heat exchanger has been replaced with a brand new one and the gas section and water section replaced with a re-furbished one.
It is all working now but the flames...
Hi, got my badge thank you AP!
My first post in the yellow badge area might seem abit silly but here it goes:
Brittony 2 multipoint, burners producing flames out of places it shouldnt including large yellow ones going outside the heat exchanger i.e burning the case. Gasket that joins onto...
First off Im gas safe Croppie gimme badge already!
Just a quick one -Brittony 2 multipoint, burners producing flames out of places it shouldnt including large red ones going outside the heat exchanger i.e burning the case. Gasket that joins onto the burners has something that looks like loctite...
Water from the tap that this feeds is scalding hot. I've checked the Aquasystem 2 litre expansion vessel that's associated with it and there's no pressure in it. The safety valves seem ok. Would this lack of pressure in the expansion vessel cause the water to become extremely hot?
hello.
we have an old Corvec Britony II gas water heater with balanced flu. . we only use it to heat water for baths , washing ,showers etc and have electric storage heaters . its time we replaced it and could i please have some recommendations for a new one with similar specs please ...
gnome
Thread
buying
gas
heater
help
multipoint
please
water
water heater
Hello Dear Plumbers,
Here's my problem:
I use a Vokera Flowmaster Gas multipoint at mains water pressure to supply hot water to kitchen and bathroom. This continues to work well after many years. But I've always had an annoying problem when using the shower which has a Triton mixer control...
Hi there,
In one of our office buildings we have a heatrae sadia multipoint 30 heating 3 basin taps in the ladies toilets and maybe another 3 in the mens, although I'm not certain of this. I have to do water temp tests each month and the temp for these taps hardly ever goes over 40 degrees and...
Hello guys,
Posted this on the plumbing forum but thought I might try on here as well.
I need to replace my mothers failing Chaff multipoint water heater and was wondering which would be the best model to replace it with. Looked at the following- Main/Volkera and Ariston. here current is a...
Had a look at a gas fired water heater today, pilot would not light. I removed pilot assembly from the supply tube, depressed control knob, there was plenty of gas there.
From this I gathered that the pilot injector was blocked. I tried to clean the injector, to no avail, so for now, water...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.