Search the forum,

Discuss heating problems please help in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
U

ukpaul

Hi all
I have a glowworm betacom 30c combi boiler
for the last 3 weeks now we have had no heating, its getting to 40-50 degrees ad then shuts down and it keeps on doing hat until I switch the boiler off, here are no airlocks in the system,
so I called out a heating engineer and a hour after he left it went back the same,
and so he called back today and spend 3 hours messing about with it,and also changed afew parts one off them was the pcb board, and its made no difference what so ever, he then told me the best bet is to get a new boiler and then left
so now am pulling my hair out of what to do/try next
can anyone help me please?
many thanks
paul
 
croppies on call :) he is supposed to be qualified
 
Last edited by a moderator:
call n a gas safe engineer YOU NEED A GOOD ENGINEER,who knows what there doing,you can stick a request up in here in the need a plumber/gas engineer section
 
Last edited by a moderator:
Status
Not open for further replies.

Reply to heating problems please help in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
2
Views
235
P
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I have changed the 3 port actuator Honeywell head however this doesn’t seem to have solved the issue, does this mean that the programmer is faulty? Or is...
Replies
8
Views
319
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
155
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Replies
5
Views
288
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
375
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock