Search the forum,

Flush valve with handle

Post new thread

Discuss Flush valve with handle in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

M

Matt0029

Gas Engineer
Messages
1,136
Has anyone if this flush valve using the handle instead of the button? Are they good?
 

Attachments

  • Screenshot_2024-01-05-13-22-42-38_40deb401b9ffe8e1df2f1cc5ba480b12.jpg
    Screenshot_2024-01-05-13-22-42-38_40deb401b9ffe8e1df2f1cc5ba480b12.jpg
    141.5 KB · Views: 10

Reply to Flush valve with handle in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

sammie81116
Sewer pipe problems not sure about it
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
494
Chuck
C
D
Pop quiz, does anyone recognise this radiator valve?
Hi Does anyone recognise the make/brand of the radiator valve. It leaks when closed and Iam hoping I can replace a seal etc?
Replies
1
Views
74
ShaunCorbs
ShaunCorbs
N
Towel Rail Valve Advice please (35 Characters needed.)
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
184
Timmy D
T
127bit
How to reinforce shower pan threshold?
The left rear floor corner is highest (the shower pan touches/sits on the floor), sloping down diagonally to the front right corner (lowest). The front right corner shim is 5/8", the left front corner is 3/8" shimmed, with shorter shims under left middle and right rear corner. The pan perimeters...
Replies
5
Views
127
Timmy D
T
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
324
Timmy D
T
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock