End Feed Fittings

Post new thread

Discuss End Feed Fittings in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
tamz, is there any danger that using a half slip will result in the fitting coming apart ?
 
New posts
Status
Not open for further replies.

Reply to End Feed Fittings in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

B
How should condensate drain connection be made at top of downpipe?
[ASIDE: I did wonder if this was the best forum for this but figured as it was a boiler related issue that the gas engineers would be dealing...
Replies
5
Views
271
Bordonbert
B
N
Service/isolating valve for outside tap -- need advice
Hello guys, a couple of months back I installed a new shower and sink into a part of the house that hadn't previously been plumbed in. This forced...
Replies
1
Views
409
Ben-gee
B
Bogart
Water leak outside property
Not exactly a plumbing problem but here goes. I have known for a couple of years there was a water leak somewhere between the water meter, on our...
2 3 4
Replies
33
Views
2K
Bogart
Bogart
O
brass, stainless, or EP/plastic for Well service line fittings
Where the black polyethelene service line enters this particular structure is by far the most freeze-prone area. The structure is an elevated...
Replies
0
Views
391
ohnoflood
O
O
Heating always on and reduced hot water temp
Hello. I wonder if someone can help. We have noticed 2 issues in our house over the last couple of weeks . We have a Glow Worm Ultracom 24cxi...
Replies
6
Views
997
John.g
J

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock