Discuss electrical connections for Siemens RAM1 Cylinder Thermostat in the Plumbing Jobs | The Job-board area at PlumbersForums.net
- Status
-
Not open for further replies.
I need to replace the immersion heater in a hot water tank, there is no boiler, and want to also fit a clamp on cylinder thermostat to make sure that the immersion heater does'nt over heat, as it has just done. The emmersion heater has three wire, L, N, and E. The Clamp on Thermostat has connections 1, 2, 3, E. As the immersion heater will be powered from a 13amp socket (on its own 15amp supply) any idea which wires go where?
Didydave.
- Status
-
Not open for further replies.
Reply to electrical connections for Siemens RAM1 Cylinder Thermostat in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Hello,
I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be?
Thanks
We are from Alberta, and I own an electrical company.
I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
