Search the forum,

Discuss dripping drain off on vented central heating in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Messages
910
If a drain off valve is leaking on a vented central heating system, due to not shutting off. As the washer has perished. Has anyone had success in swapping the inners over in this without draining down, if quick?
 
If a drain off valve is leaking on a vented central heating system, due to not shutting off. As the washer has perished. Has anyone had success in swapping the inners over in this without draining down, if quick?
Do mean an mt cock ? Its a drain for heating system located below the head of water for the system. .Rob Foster aka centralheatking
 
I have had to unscrew and remove the brass part and sometimes poke a small slotted screwdriver in the drain to break/remove the old washer.
This is a good reason for not using soldered draincocks, but rather 1/2” threaded into F.I. fittings where suitable, so the entire draincock can be swapped easy
 

Reply to dripping drain off on vented central heating in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi, I have a Worcester 28i junior boiler that has started to lose pressure, only when using the central heating. When using hot water I have no issue, however, when running the heating the pressure drops. Im looking for some ideas on what could be causing this. I have no sign of pipe leaks...
Replies
6
Views
205
Can anyone remember the Mira mixer shower that would work down to a really low pressure on a vented hot water system without a shower pump?
Replies
2
Views
140
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
150
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
374
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
2
Views
231
P
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock