Discuss Drill through granite worktop in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

hammers4spanner

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
7,712
Need to go through with a condensate pipe. It' granite transformation so about 5 mm thick.
What do you guys suggest to use ?
 
Need to go through with a condensate pipe. It' granite transformation so about 5 mm thick.
What do you guys suggest to use ?

Do what you usely do Big Hammer lol :)! is it proper Granite ? what about those diamond sets that drill ceramic tiles ?
 
All I know it' called granite transformation.
They lay it on top of existing worktops
 
Just googled the stuff to see what it is and they have stockists and showrooms with phone numbers, give a couple of them a call tomorrow and see what they say.
 
All I know it' called granite transformation.
They lay it on top of existing worktops

Diamond hole saw then I suppose an ordinary hole saw or flat bit saw to get through whatever the granite has been laid on.

Tile Diamond Holesaw 25mm
 
Last edited:
Agreed on diamond hole saw. I use these ones

Erbauer Diamond Tile Drill Bit 25 x 80mm

Very good for the money. Trouble is with the one above is they don’t last long! You might find you drill half the hole and it’s dead.
 
Agreed on diamond hole saw. I use these ones

Erbauer Diamond Tile Drill Bit 25 x 80mm

Very good for the money. Trouble is with the one above is they don’t last long! You might find you drill half the hole and it’s dead.

Those bits aren't the best quality that's true but are easily killed when pressing too hard and overheated so the diamond coating gets glazed, they can be redressed or at least partially so by using on something softer but then the OP only has to drill through 5 mm.
 
Last edited:
What do you use to guide them through?
Don't want them sliding all over thje worktop
 
You can start it by hand, use your spare hand as a guide, lightly hold around the bit (gloves), drilling slowely and gently to start, hold the drill at a slight angle so one edge bites. Don’t push down hard. Or you can buy the suction guide, but you may not have room for this up against the wall?
 
Status
Not open for further replies.

Reply to Drill through granite worktop in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Morning all. What size diamond holesaw do you use for drilling the hole in a quartz countertop for a basin waste to go through? I have a house...
Replies
10
Views
917
Hello guys, an easy one: I recently had to drill through two outside walls to run 15mm pipes for a shower and sink. The holes are neat enough but...
Replies
1
Views
481
I'm on a new build the boiler is in the garage. I have the option of drilling straight out with the condensate in to the stack. Or drilling...
Replies
13
Views
1K
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16...
Replies
0
Views
240
Hello I'm going around in circles trying to find a new kitchen sink. We want a white one, ideally a more modern look like granite or composite...
Replies
4
Views
891
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock