Search the forum,

Danfoss RAS-C2 removal

Post new thread

Discuss Danfoss RAS-C2 removal in the USA area at PlumbersForums.net

H

hhstu

Messages
4
Hi have just bought the hive TRV's and I'm trying to fit them I have the Danfoss RAS-C2 currently I have managed to unscrew the gray bit and the hole head turns but I cant get it to come off am I missing a step? I didn't install them they came with the house.
ae235.jpeg
15757152058967937167854885888717.jpg
15757152484311673958165804679192.jpg
 
Last edited:
Wiggle and pull defo your on the right lines just pull
 

Reply to Danfoss RAS-C2 removal in the USA area at PlumbersForums.net

Similar plumbing topics

R
squeaky grohe bathroom tap 2 months old
Hi bit of a weird issue, I installed a grohe bathroom tap successfully 2 months ago bought from screwfix. Last week the right hand hot tap makes a squeak noise as I turn it on or off, left tap is 100% perfect and noiseless. This grohe tap is like one unit, so no screw notch or way I can remove...
Replies
1
Views
90
Lou
Lou
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
197
SimonG
SimonG
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
117
Lou
Lou
N
Towel Rail Valve Advice please (35 Characters needed.)
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
184
Timmy D
T
C
Y Plan, no hot water but heating is working when called
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I have changed the 3 port actuator Honeywell head however this doesn’t seem to have solved the issue, does this mean that the programmer is faulty? Or is...
Replies
8
Views
277
John.g
J
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock