Discuss blocked cold feed in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

mutley racers

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
5,171
I haver never seen a 22mm choked up this bad before. And this is apparently after a flush a couple of yrs ago. Which they had because water wasn't getting hot. But, the little hole actually did end up heating the cylinder.

20140305_124911.jpg20140305_124858.jpg



Replaced with an 824. Couldn't see any rubber hoses inside?

20140305_170233.jpg
 
Status
Not open for further replies.

Reply to blocked cold feed in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Ok I have been dealing with this problem for over a year and finally have to ask for some help as backflushing every 2 weeks or so is getting very...
Replies
5
Views
1K
Hi Just had a new bathroom installed with a toilet bowl that reaches the back wall. Its has a bottom entry cold feed to the cistern. The fitter...
Replies
12
Views
1K
Closed heating system, approx 14 years old with oil fired boiler, feeding around 18 radiators over 2 floors. One small radiator nearest the...
Replies
4
Views
1K
Hi Everyone, For those who like a long read but I could rally do with some advice. Might be a bit long this. For background. A...
Replies
3
Views
290
Hi, I wonder if you could help me. The overflow pipe drips intermittently from the large cold water storage tank in the loft. Not the small F and...
Replies
4
Views
964
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock