Search the forum,

fitting 40mm pipe into soil stack using strap boss question

Post new thread

Discuss fitting 40mm pipe into soil stack using strap boss question in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
P

plumbduff

I would like to add a 40mm waste pipe into this old fitting on the soil pipe shown in the photograph below.
There is 50mm clearance between the the bottom of the inlet pipe and the soil pipe rim just enough room (I think) to put the strap around.
The diameter of the pipe fitting is the same as the soil pipe and the plastic reacts to solvent weld glue.
If I can get it to fit is this a practical solution?
soil pipe conection.jpgstrap boss.jpg
 
I`m now wondering that you are more than an average home DIYer coming here for advice tbh.
How many properties are you working in?
 
rpm said:
I`m now wondering that you are more than an average home DIYer coming here for advice tbh.
How many properties are you working in?
Click to expand...
Hi
It's all on the same property and the same project - this is the same soil stack mentioned before. I'm refurbishing my bathroom and I'm no professional that's for sure!
Just want a bit of helpful advice
 
no you cant as its a bigger dia and the strap wont fit replace the t

and as above if your working as a plumber you should know the basics before you quote/ are doing a job
 
BTW I'm not a plumber
Can't remove T without huge disruption.
The strap should fit:
http://www.NoLinkingToThis/p/floplast-sp319g-strap-boss-grey-110mm/93635
If it can't be done this way I have an alternative plan.
 
plumbduff said:
Same - different angle and some floor boards removed though
Click to expand...

I`m not getting in to an argument with you as camera angles can alter a picture however it looks different to me.

I`m out.
 
plumbduff said:
BTW I'm not a plumber
Can't remove T without huge disruption.
The strap should fit:
http://www.NoLinkingToThis/p/floplast-sp319g-strap-boss-grey-110mm/93635
If it can't be done this way I have an alternative plan.
Click to expand...

Still won't fit
 
Judging by picture, which might be deceiving?
You can't attach another pipe there because of the danger of cross flow.
 
Status
Not open for further replies.

Reply to fitting 40mm pipe into soil stack using strap boss question in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

U
Below Ground Soil Pipes on Self Build Bungalow
Just started gound work on self build bungalow and wondering best way to do below ground soil pipes. For toilet I was going to go straight down through slab and out through deadwork into a manhole. I will work out falls from manhole and set the height of the waste water system as required. For...
Replies
2
Views
102
umiq88
U
A
copper vs pushfit pipes
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
242
Chuck
C
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
187
dreikher
dreikher
T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it šŸ˜¬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
265
ShaunCorbs
ShaunCorbs
D
Covering shallow sewer pipe under concrete Patio
Hello all, Iā€™m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. Iā€™m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
232
DIwhYdidIstartThis
D
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tiling Forums UK
Tile Forum
Tiling Forum UK
Contractor Talk
Tilers Forum
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock