Discuss What the hell is this pipe? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Doesn't look like PP to me.


Not PP. But PF. Think it's made by polypipe.PolyFit 15mm Equal Tee | PolyFit Pushfit Fittings image.jpg
 
Use a compression fitting then. All manufacturers will accept compression as a transition between different brands.

As longs the correct insert has been used.. JG don't allow there super seal ones, it has to be the rigid ones
 
Don't John Guest say there speedfit fittings can be used on any pipe? Even if you get the correct fitting and it blows off, you wont have a leg to stand on and you will be claiming through your insurance anyway.
 
All pipes are the same od you can use any fitting with any pipe just use the correct inserts
 
Status
Not open for further replies.

Reply to What the hell is this pipe? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic...
Replies
2
Views
323
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m...
Replies
6
Views
326
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16...
Replies
0
Views
241
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to...
Replies
9
Views
335
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock