Search the forum,

Weird tap started dripping

Post new thread

Discuss Weird tap started dripping in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

S

SteveH2

Messages
3
This tap is dripping through the spout, just a bit
see photos, robf shows when closed, robo shows when open and rob3 shows a side view
I don't think it can be the washer. We've given it a good vinegar soaking and scrubbimg.
Any ideas please
Can anyone identify the type or the maker. It's getting on for 20 years old
Thanks
 

Attachments

  • robf.png
    robf.png
    520.8 KB · Views: 4
  • robo.png
    robo.png
    442.3 KB · Views: 4
  • rob3.png
    rob3.png
    934.4 KB · Views: 4

Reply to Weird tap started dripping in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

P
Viessmann combi starts when cold, mixer, tap is opened
Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
200
ShaunCorbs
ShaunCorbs
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
187
dreikher
dreikher
W
Outdoor Tap at Porch
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
226
Dave Moore
D
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
200
SimonG
SimonG
P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
331
Chuck
C
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tiling Tools
Electricians' Talk
Tiling Forum
Tilers Forum
Tiling Tools
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock