Search the forum,

Discuss undersink water heater recommendations? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

cdodds2004

Plumbers Arms member
Plumber
Gas Engineer
Messages
819
Got to fit a couple of these in a local church, doing a bit of reaserch and looked at a few different units but wondering if anyone had any recommendations on a decent quality one.

Local merchant stocks Hyco, and crown but will order me anything in i need :)

thanks :)
 
santon or ariston is good (the only thing they make is worth any salt)
 
+1 for ariston, that was the last 1 I fitted and seemed decent enough.
 
Havent seen one in ages but I still think they make them , zip ...... A pal had one in his factory for years , brilliant thing.
Recently I have used a few Hyco units , very cheap ( or used to be ) and they have been fine .
 
Havent seen one in ages but I still think they make them , zip ...... A pal had one in his factory for years , brilliant thing.
Recently I have used a few Hyco units , very cheap ( or used to be ) and they have been fine .

there ok until they go wrong and price is steep and spare prices are stupid
 
Havent seen one in ages but I still think they make them , zip ...... A pal had one in his factory for years , brilliant thing.
Recently I have used a few Hyco units , very cheap ( or used to be ) and they have been fine .

Sound. Have you had any over a decent period of time? Need it to be reasonably long lasting
 
One is on about 4 years now ( you know whats going to happen now lol ) , personaly I didnt think it would get that far.
 
Where are you based pal ?


telford doe !! I am a tosser , sorry theres a first call gas not far from here , obviously not you
 
Last edited:
Sound. Have you had any over a decent period of time? Need it to be reasonably long lasting

how long is long normally they only last about 5-8 years depending on use

could you fit a small direct unvented cylinder somewhere? will last longer
 
how long is long normally they only last about 5-8 years depending on use

could you fit a small direct unvented cylinder somewhere? will last longer

did look at that first but literally no room its in a small catering unit in the corner of a church for there coffee mornings etc
 
Status
Not open for further replies.

Reply to undersink water heater recommendations? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
252
Hi All I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Replies
0
Views
234
  • Sticky
Morning to any Australians lurking around! Register its free, then message me, I'll sort your account out for you. We will need a moderator from each main country too. I'll post this in the Australian forum now.
Replies
0
Views
79
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
Replies
2
Views
140
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
234
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock