- Messages
- 5,172
I have an install coming up where I need to run a new gas carcass about 15metres. I need it to run along the floor at ground level and then it will need to go up the corner of a wall to the 1st floor of the building. It will be boxed in and so am wondering how tight are the bends you can pull with this stuff? As I need it to be as tight as possible to minimise the size of boxing required?
i see they do not sell elbows for this piping, so it must be pretty tight am thinking. I have been wanting to try this stuff for a while now and I can see my opportunity
i see they do not sell elbows for this piping, so it must be pretty tight am thinking. I have been wanting to try this stuff for a while now and I can see my opportunity