Users can remove all display ads (not sponsors) for a small fee. Click for info (must be logged in)

Discuss tap removal in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

wiggers

Plumbers Arms member
Plumber
Messages
208
im about purchase a bear hug wrench or a monument stiff nut removal kit has anyone used or can recommend any of these tools?
 
I've had the rothenburger telescopic tap wrench in the past but it's usually far too bulky in tight spaces and the telescopic bit seizes up rendering that part of it useless. I've had a lot better time using the monument type with changeable heads, one for baths one for basins and sinks. Sometimes it just requires brute force! Especially on a cast iron bath!
 
I've got the bear hug one & find it pretty good.
 
ive got jaw droppers and bear huggers prefer the jaw droppers
 
the armeg jaw droppers are they strong enough to undo 20 yr old seized backnuts?
The bear huggers look much stronger but too bulky foy getting under basins
 
Just googled these jaw droppers, can't believe I haven't seen them before! ÂŁ50 seems a bit steep tho
 
Never quite worked out the fuss with the Jaw Droppers.

I use a basic monument basin wrench, with the two different size heads. Its not sprung, or ratcheting, or fancy in any way. Its slim, and simple and nearly always does the job without a fuss.
 
im with danny im on my third and probably last set of monuments very seldom they fail and ive yet to see anything that looks like it will do any bette,rwhat ever you use theres going to be the odd tap that will have to be cut out
one tip is ,to reach the far bath tap easier take the overflow out im always amazed how many people struggle round it
 
Status
Not open for further replies.

Reply to tap removal in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new...
Replies
1
Views
257
Hi bit of a weird issue, I installed a grohe bathroom tap successfully 2 months ago bought from screwfix. Last week the right hand hot tap makes...
Replies
7
Views
478
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about...
Replies
7
Views
255
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
213
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
210
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock