Discuss Stupid question time in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

Millsy 82

Plumbers Arms member
Plumber
Gas Engineer
Messages
4,352
Do you just mix and match shower trays and screens or if you buy one do you have to get the correct screen for it.

I don't fit many bathrooms and the ones I do most customers supply the bits.
 
Some trays have a different radius position and the doors won't look right. But most are fairly close.
If you buy a tray and doors, which have the rounded top and bottom sections seperate, - put one of these on top of tray to compare before you fit tray, if in any doubt.
 
Last edited:
Status
Not open for further replies.

Reply to Stupid question time in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello all, I'd like to get some advice on the following issue. We have relatively large tiles (see image 1), and the idea was that the vertical...
Replies
9
Views
684
Size of bathroom 230cm x 210cm Height 230cm Birmingham Area Initial problem Burst pipe underground in bathroom, concrete. Have had this dug up...
Replies
0
Views
341
L
Good morning, I have a hinged shower screen for my bath that I don't have fixings for. The guide holes in the screen line up with guide holes in...
Replies
1
Views
367
I've got an issue with the shower tray not being totally flat. As you can see from the photos, it is about 7mm out at one side. It's leaning...
Replies
5
Views
576
Hi all, I have a couple of leaks coming under shower tray downstairs. One is along the wall so think might be joint between wall and tray and...
Replies
0
Views
288
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock