Discuss Replacing expansion vessel on... in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

mutley racers

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
5,171
A vailliant turbomax plus. This one has the flue that exits the back of the boiler. Is it easy to take this off the wall and put back together?

Cheers
 
You would need new flue seals as there know for being buggers but yea
 
i would allow upto half a day for your first but normally 2-3 hours

you can do them under 2 if you know what your doing
 
Status
Not open for further replies.

Reply to Replacing expansion vessel on... in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

    • Like
Looking for someone that can replace the expansion vessel on an old heating system that is losing pressure every day and needs topping up at least...
Replies
2
Views
475
I think I looked into it a few years ago. That a modern 200litre unvented cylinder would need a higher litre expansion vessel then one that was...
Replies
2
Views
144
hello we have an unvented system. we have an issue where the hot water is hot for 10 seconds and then luke warm, turn off taps / wait and turn...
Replies
5
Views
728
Hi How simple is it to replace the expansion vessel hose? Do I simply turn the boiler off, drain the boiler and swap hoses, using some PTFE tape?
Replies
0
Views
387
Vaillant Ecotec Plus 832 boiler is 13 years old, 4 of which since we've been living there, started to play up in last couple of months. An...
Replies
5
Views
312
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock