Search the forum,

Discuss Radiator vale & drain cock in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

rocketmanbkk

Plumbers Arms member
Plumber
Messages
4,113
Hi Friends

I am going to move a radiator in my house, does it matter if the drain cock is on TRV or Lockshield end?

I see at Sscrewfix you can buy chrome one atached to the valve (it looks like a lockshield).

Thank you
Rocket
 
just get the lockshiled with the built in drain valve, but you can put a drain valve on any side doesnt matter
 
Last edited:
you can get lockshield valves with integrated drains like you have found, but i prefer to put drain in the pipework wherever possible.
 
they are not ideal for draining systems, but that's where a wet vac comes in handy :p
 
the built in drain ofs are next to useless for draining the system they are realy for drop systems where each rad needs a drain down point
 
thats why i much prefer putting drainoffs onto pipework wherever possible.
 
Status
Not open for further replies.

Reply to Radiator vale & drain cock in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
234
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
2
Views
247
P
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
559
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
398
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
263
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock