- Messages
- 4,294
would you be willing to sell some (ie one or two boxes)?
To be honest I use this stuff all the time
Discuss P,d,m brass fittings is it for imperial or metric pipe? in the Plumbing Jobs | The Job-board area at PlumbersForums.net
would you be willing to sell some (ie one or two boxes)?
You can get solder ring (identical to Yorkshire) 3/4" x 22mm connectors in other brands
To be honest I use this stuff all the time
Williams do them in endfeed and solder ringlink as have asked locally for a few years and they say the only ones they know of are yorkshire (which dont make them any more) or endfeed
(decent ones)
I went after college to do a homer but I had limited material as I didn't know what to expect. I Went to change the bath taps for a bath mixer but before I cut any pipe I noticed the brass fittings are stamped p,d,m can someone tell me if the copper pipe will be metric or imperial. So I know if I need green rings for next time I go round I'll be prepared.
Any old skool plumbers out there I just want to say I respect the patience and skill that was involved compared to nowadays.
as this bath pipe work must of been done first then the bath.
Good idea I'll do that. I didn't know you can get imperial and metric yorkie couplin. Amazing the stuff you can buy nowadays.
If you're talking about brass soldered fittings on existing pipe, then I would think it will be original 3/4
Do you have to change pipe work to change taps, maybe enough play in pipes to accommodate new taps
The thread length should be similar
link as have asked locally for a few years and they say the only ones they know of are yorkshire (which dont make them any more) or endfeed
(decent ones)
Reply to P,d,m brass fittings is it for imperial or metric pipe? in the Plumbing Jobs | The Job-board area at PlumbersForums.net
We get it, advertisements are annoying!
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.