Search the forum,

Mira Shower Removal

Post new thread

Discuss Mira Shower Removal in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
P

Paulhar

Messages
25
Hi All,
Can anyone tell me which model of Mira manual mixer shower this is. Also, any info on how to get it off the wall would be much appreciated.

Cheers

Paul
 

Attachments

  • 2012-01-23_16-46-04_612.jpg
    2012-01-23_16-46-04_612.jpg
    73.4 KB · Views: 24
Sorry I can't remember the model, I've only taken 1 out. Pipes are in the wall I'm afraid, to replace with new you might have to change the pipe set up
 
i think i have removed one like this yonks ago. firstly isolate the water to it. undo the nuts on the side of the mixer and then turn the body to either the right or left-can't remember which-and then remove it. i think behind the chrome collars there are two more nuts which will let you remove the two bent pieces.
 
Yes, I have been at identical one for repair. It is a old Mira 88 I was told by agents. Can still get spares for them.
 
Status
Not open for further replies.

Reply to Mira Shower Removal in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
194
SimonG
SimonG
F
Mystery Mira Elite QT Leak
Hi All I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Replies
0
Views
229
Firefox
F
P
Viessmann combi starts when cold, mixer, tap is opened
Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
200
ShaunCorbs
ShaunCorbs
jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
286
oz-plumber
O
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
322
Timmy D
T
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock