Discuss Loud banging from Worcester Bosch Greenstar 24i Junior in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Can I measure the flow rate easily without one of those special cup meters?
 
Sorry I was wrong you can fill a bucket and time it never done it myself
 
Run the tap until it gets hot, then fill a bucket from your hot tap for 60 seconds, then decant the bucket into a measuring jug eg 1 litre at a time and this will provide your flow rate.
 
Someone checked the flow rate of the hot water for me today - it was around 5 litres/minute. As cdodds2004 mentioned in the previous post, it should be 9.8 litres/minute.

It was suggested that a clogged diverter valve could be the cause - is this likely?
 
Edit: Do you mean the small filter inside the turbine?
 
Last edited by a moderator:
New posts
Status
Not open for further replies.

Reply to Loud banging from Worcester Bosch Greenstar 24i Junior in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up...
Replies
2
Views
286
PSxxxxxx
P
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I...
Replies
8
Views
398
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about...
Replies
7
Views
259
IS IT POSSIBLE TO ADJUST THIS MIXER UNIT? WE HAVE TO HAVE IT TURNED ALMOST FULLY ANTI CLOCKWISE TO GET HOT WATEROUT. THE FRONT PLATE WITH MIRA ON...
Replies
6
Views
290
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the...
Replies
5
Views
329
Back
Top