Search the forum,

Kitchen fitters.....

Post new thread

Discuss Kitchen fitters..... in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Scott_D

Scott_D

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
6,131
IMG_2210.JPG
Can't take the front off
 
Well cants a big word just more time and a multi tool :)
 
Status
Not open for further replies.

Reply to Kitchen fitters..... in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
153
Lou
Lou
F
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
5
Views
495
FozzieBear
F
Lou
Show us your fanciest radiators you have installed!!
Show us your fanciest radiators you've installed! We would love to see them! I love this Milano vertical radiator in the kitchen space. What do you think?
Replies
4
Views
217
Timmy D
T
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
372
Timmy D
T
C
Mira shower mixer adjustment.
IS IT POSSIBLE TO ADJUST THIS MIXER UNIT? WE HAVE TO HAVE IT TURNED ALMOST FULLY ANTI CLOCKWISE TO GET HOT WATEROUT. THE FRONT PLATE WITH MIRA ON IT PRISES OFF AND INSIDE THERE ARE SOME PLASTIC BITS AND A SMALL CROSS-HEAD SCREW IN THE MIDDLE. THANKS
Replies
6
Views
241
cheddarman
C
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Contractor Talk
UK Tiling Forum
Plumbers' Talk
DIY Forum
BS 5389 Tiling Standards
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock