Search the forum,
  • Thread starter Barry98
  • Start date
  • Replies 43
  • Views 4K

Discuss JOTM competition entries in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
B

Barry98

Same rules boys and girls stick them in here then ill set a poll up at the end of the month to vote in.

Good luck prize to be confirmed.
 
pic not very good and dont know why they are on the side ?..
 

Attachments

  • image.jpg
    image.jpg
    70.4 KB · Views: 58
  • image.jpg
    image.jpg
    65.3 KB · Views: 50
  • image.jpg
    image.jpg
    81.6 KB · Views: 57
  • image.jpg
    image.jpg
    72.4 KB · Views: 55
  • image.jpg
    image.jpg
    88.5 KB · Views: 57
  • image.jpg
    image.jpg
    81.1 KB · Views: 58
  • image.jpg
    image.jpg
    68.6 KB · Views: 56
  • image.jpg
    image.jpg
    73.6 KB · Views: 52
  • image.jpg
    image.jpg
    82.5 KB · Views: 53
I'm working on mine over the next couple of days. Was going to use the pics from me garage conversion but no newspaper.
 
Can I enter a kitchen next week?
 
ImageUploadedByTapatalk1358280992.719368.jpgImageUploadedByTapatalk1358281018.454231.jpgImageUploadedByTapatalk1358281035.323658.jpg

Had a couple of nice installs this month, here's one.
 
Last edited:
Thanks matey.
 
Cracking job that. Nice to see copper on show.

But I'm docking you a point for leaving the filling loop flex attached :) :) :) :)
Photo was taken during commissioning ;)
 
If you look really close...

Whn1_JOTM_2011.jpg
 
Last edited:
Both entries are the best lookin bathrooms I've ever seen. Now where did I put those glasses?

Damn glasses fell off while turning my head to the left to look at Dancins photos. Now got a squint in my left eye and a crick in my neck.
 
Where's the ABV built in?
Docking points for condensate not up sized as garages are classed as external
NO lagging around cylinder for part L
No Top immersion kit cheapskate alert.....





"Shut the f* ck up Vern it's lovely...........ok I will"

Seriously......Top drawer fella a lot of thinking went into that, nice to see PRV above bubble level too!
 
It's work in progress also not a garage anymore, it's a utility room, doors getting blocked up so nernerner ;)
 
Abv is built in but it's very small bore keep meaning to fit my own in.
 
Status
Not open for further replies.

Reply to JOTM competition entries in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

B
Hi, I've followed this excellent forum for several years but have never posted, so decided I'd better give some details. My status is the upper end of DIY and I've a couple of house renovations under my belt (my own homes) I am retired but do volunteer handyman jobs for the elderly. Not...
Replies
0
Views
27
B
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
223
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
321
Hi all, I'm installing a concrete patio out back. By the wall under the kitchen sink I have an existing P-Trap gully for the grey water from the sink, dishwasher, washing machine etc. When I pour the concrete there won't be any chance to dig it up anymore. From my own research I get the...
Replies
0
Views
82
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
186
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock