Search the forum,

JOTM competition entries

Post new thread
  • Thread starter Barry98
  • Start date
  • Replies 43
  • Views 4K

Discuss JOTM competition entries in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
No ive won
2ery8a5u.jpg
 
BOD said:
No one did the wasn't enough interest to keep it going
Click to expand...

I don't really think we have the type of job where this type of competition is sustainable.

A lot of our work is repair based and we can't really post a picture up of a new rad valve or TRV. When it comes to installation, once you've seen one rad on a wall, or new boiler or cylinder you've seen them all.

Unless someone's fit a sexy new stylish bathroom then its a fair photo to post, but jobs like those a few and far between.
 
I'll enter if you don't mind seeing endless tap swaps or blocked toilets flushing again. Maybe even the odd bathroom swap - excluding wall tiles.
 
New posts
Status
Not open for further replies.

Reply to JOTM competition entries in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

B
Posting a thread as until now I've only read the forum
Hi, I've followed this excellent forum for several years but have never posted, so decided I'd better give some details. My status is the upper end of DIY and I've a couple of house renovations under my belt (my own homes) I am retired but do volunteer handyman jobs for the elderly. Not...
Replies
0
Views
27
Bob Kerr
B
B
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
223
oz-plumber
O
P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
322
Chuck
C
D
Replacing outdoor P-Trap Gully with Bottle Gully
Hi all, I'm installing a concrete patio out back. By the wall under the kitchen sink I have an existing P-Trap gully for the grey water from the sink, dishwasher, washing machine etc. When I pour the concrete there won't be any chance to dig it up anymore. From my own research I get the...
Replies
0
Views
82
DIwhYdidIstartThis
D
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
186
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock