Search the forum,

Ikea RENGÖRA Replacement Dishwasher

Post new thread

Discuss Ikea RENGÖRA Replacement Dishwasher in the USA area at PlumbersForums.net

S

Stampy

Messages
2
Hi All,

Can anyone help me find an alternative to an Ikea RENGÖRA dishwasher?

Ours is eight years old and has finally gone buggy. It only washes using cold water, so I expect the heating element is gone.

There is a twist.

We live in The Netherlands, so it's a tad more complex than ringing up Curries.

I looked at this one, QuickSelect AirDry Inbouwvaatwasser - FSB52907Z | AEG - https://www.aeg.nl/kitchen/dishwashing/dishwashers/built-in-dishwasher/fsb52907z/, but the thing that's got me tied up in knots is the door type. The dimensions seems to be the same, but I am struggling.

RENGÖRA Dimensions

1605604118638.png


AEG Dimensions

1605604209628.png


Any help would be most welcome!

Regards

Stampy
 

Attachments

  • 1605604139705.png
    1605604139705.png
    88.2 KB · Views: 2

Reply to Ikea RENGÖRA Replacement Dishwasher in the USA area at PlumbersForums.net

Similar plumbing topics

F
  • Question
No Hot water, Fixed and Broken Again Ideal Logic 24
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
114
Lou
Lou
D
Covering shallow sewer pipe under concrete Patio
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
226
DIwhYdidIstartThis
D
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
95
Lou
Lou
T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it 😬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
260
ShaunCorbs
ShaunCorbs
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
183
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock