Search the forum,

How to remove a Stuck tap cover

Post new thread

Discuss How to remove a Stuck tap cover in the USA area at PlumbersForums.net

D

Debs

Messages
7
I am trying to remove the round cover on a tap to get to the tightening screw. It used to screw off but is stuck fast. Any ideas how to loosen this. Many thanks
 
Pour boiling water over then try wearing rubber gloves (the kind with the little bobbles give a better grip).
 

Reply to How to remove a Stuck tap cover in the USA area at PlumbersForums.net

Similar plumbing topics

C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
201
SimonG
SimonG
R
squeaky grohe bathroom tap 2 months old
Hi bit of a weird issue, I installed a grohe bathroom tap successfully 2 months ago bought from screwfix. Last week the right hand hot tap makes a squeak noise as I turn it on or off, left tap is 100% perfect and noiseless. This grohe tap is like one unit, so no screw notch or way I can remove...
Replies
3
Views
134
ShaunCorbs
ShaunCorbs
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
231
DIwhYdidIstartThis
D
N
Towel Rail Valve Advice please (35 Characters needed.)
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
191
Timmy D
T
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
135
Lou
Lou
Creating content since 2001. Untold Media.

Newest Plumbing Threads

UK Tiling Forum
Tiling Advice
Plumbers Forum - Plumbing Advice
Electrical Forum for Electrical Advice
British Standards in Tiling BS5389
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock