- Messages
- 578
Am sure is not me as I have done end feed fittings before with no problem.
What I am experiencing is that after cleaning up the fitting and the pipe they slip into each other fine but after I apply flux they do not. If I try to turn the fitting on the pipe a lot of the time it is very hard whereas I should have thought would even be easier with flux on it. The flux is fine clean and not full of crap!
What I am experiencing is that after cleaning up the fitting and the pipe they slip into each other fine but after I apply flux they do not. If I try to turn the fitting on the pipe a lot of the time it is very hard whereas I should have thought would even be easier with flux on it. The flux is fine clean and not full of crap!