Search the forum,

Copper or brass olive for chrome pipe

Post new thread

Discuss Copper or brass olive for chrome pipe in the USA area at PlumbersForums.net

M

midsman

Messages
54
Hello all. I hope you are having a nice weekend. I’m adding a new rad to my bathroom and will be using chrome pipe. It’s my understanding that compression fittings can be used straight on the chrome without filing of chrome finish. What olive is best to use. Copper or brass?
Many thanks.
 
midsman said:
Hello all. I hope you are having a nice weekend. I’m adding a new rad to my bathroom and will be using chrome pipe. It’s my understanding that compression fittings can be used straight on the chrome without filing of chrome finish. What olive is best to use. Copper or brass?
Many thanks.
Click to expand...
Brass on a chrome pipe as it,s hard.
 
copper for me unless its solid brass or very thick copper then i would use brass
 

Reply to Copper or brass olive for chrome pipe in the USA area at PlumbersForums.net

Similar plumbing topics

A
copper vs pushfit pipes
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
229
Chuck
C
W
Outdoor Tap at Porch
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
221
Dave Moore
D
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
188
SimonG
SimonG
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
182
dreikher
dreikher
D
Covering shallow sewer pipe under concrete Patio
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
224
DIwhYdidIstartThis
D
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock