Search the forum,

ContractorForum: Pre-Sealing Riven Slate floor tiles: Hi, I'm looking at laying som

Post new thread

Discuss ContractorForum: Pre-Sealing Riven Slate floor tiles: Hi, I'm looking at laying som in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Status
Not open for further replies.

Reply to ContractorForum: Pre-Sealing Riven Slate floor tiles: Hi, I'm looking at laying som in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

W
Outdoor Tap at Porch
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
254
Dave Moore
D
A
copper vs pushfit pipes
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
274
Chuck
C
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
211
dreikher
dreikher
D
Covering shallow sewer pipe under concrete Patio
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
265
DIwhYdidIstartThis
D
B
Brass tap body is leaking.
I have attached an image of the brass body within a tap. Having replaced a cartridge which has cured a leaking tap, I can see that there is a small leak from the brass body which can be unscrewed. Is there a seal behind the body? Thanks.
Replies
2
Views
324
Bp89
B
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Electrical News
Plumbers Forum - Plumbing Advice
Tiling Forums UK
Tiling Tools
Tiling News
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock