Search the forum,

Discuss Can I run 2 gas boilers off the same gas supply ? in the Central Heating Forum area at PlumbersForums.net

Messages
11
Hi,
Can I run a conventional central-heating-boiler + an instantaneous hot water boiler, off the same gas supply ?

Many thanks
 
depends on what meter you have also depending on what kw appliances you are planning for
 
depends on what meter you have also depending on what kw appliances you are planning for

Thanks for the reply.
That's what I thought.

How do I find out what the max output of the supply is?
Is it stated on the gas meter?

Then I assume that the boilers will state what supply they need ?

Is that it, or is there any formula that needs to be applied?
eg: Is it just that both boilers total usage must be within the total output available from the meter, or does there have to be some % less?

Can both boilers be fed from the same gas pipe, or should there be two seperate pipes tee'd off from the meter?

Many thanks
 
Yes should be in m3/h

Correct 30kw and a 30kw water heater will be fine or 40kw and 20kw etc

Correct total needs to below rated capacity

You can supply both from the same pipe but needs to be sized correctly
 

Reply to Can I run 2 gas boilers off the same gas supply ? in the Central Heating Forum area at PlumbersForums.net

Similar plumbing topics

  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
147
  • Article
A Plumber Who Worked Illegally Gets A Suspended Sentence After Falsely Claiming To Be Gas Safe Registered. A Plumber in Herefordshire was prosecuted after Hereford Trading Standards Team found that he was falsely claiming to be on the Gas Safe Register when he was not, putting members of the...
Replies
0
Views
192
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Replies
5
Views
274
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
5
Views
494
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
198
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock