Discuss Boiler lockout in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
I am furious!!!!
The guy said the main boiler exchanger needs to be changed and it won't be done before Tuesday onwards.
 
Last edited by a moderator:
Also the Biasi engineer didn't look shocked by the installation.

When I told him there was hot water going into the flushing system he looked puzzled and just said it shouldn't be happening.
 
I'm afraid that doesn't say much for the engineer.Be very afraid !
 
First he puts the condense on the cistern, a cistern without an over flow at that, then he wants to call out biasi to sort out his dodgy install. And its a landlord job? Whats the odds this job isnt registered and the installers not gas safe? Sorry for your troubles fabien. Get a full report from the biasi engineer and use it to get your land lord to get a decent gas safe installr to sort it out.
 
Hi fabien, I see it was the heat exchanger that was at fault, bad luck about not getting it fix`d untill next week ! What is going to happen about the condense pipe ?? Did you know that this water is slightly acidic ? and when your boiler is working can discharge 1/2 Ltr of water each time !!
 
What is going to happen about the condense pipe ?? Did you know that this water is slightly acidic ? and when your boiler is working can discharge 1/2 Ltr of water each time !!

If i had not been on that forum i would never have known what is going on with the boiler so thanks again everyone.
Because installation is not illegal i don't think landlady is going to do anything. And i can't afford to get someone in to sort out this mess. There is not much i can do.
 
Fabien,I repeat,talk to Gas Safe.The installation is not to regulations,that is,not to the manufacturers specification.They will make the installer rectify the problem,or,remove him from the register.
Also, I suggest that you tell your landlady that,unless she wants continual bills to repair the water leaks through the ceiling,she ought to do something.
Buster
 
The condense seems to be attached to cistern overflow. Definately not correct but should not account for system failure. Can you trace the copper pipe, furthest right and see where it goes to?, This is discharge pipe and if there are signs of water at end, it may account for why system losing pressure. if it is that then the engineer will need to replace the pressure relief valve. if not that then there is probably a leak on system somewhere, probably under cupboard floor if recent posts anything to go by.<br><br>Worth pointing out to land lady that boiler not installed correctly though.
 
Status
Not open for further replies.

Reply to Boiler lockout in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

P
  • Question
Boiler is SIRIUS THREE FS 70 Potterton commercial. Situation: We are small building contractors and my labourers managed to damage the radiator...
Replies
2
Views
143
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer...
Replies
4
Views
291
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the...
Replies
5
Views
327
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my...
Replies
3
Views
571
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
223
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock