Search the forum,

Alcove off fireplace - size of air vent?

Post new thread

Discuss Alcove off fireplace - size of air vent? in the USA area at PlumbersForums.net

J

Justice League

Messages
150
So the fireplace will be turned into an alcove where we can add a nice vase and light as a centrepiece as we have had the olf gas fire removed.

We shouldn't block the fireplace up as it can lead to condensation so what size hit n miss air vent should I add to the top of the alcove. It will be hiddent from view.

I can go with a 9 x 3 or 9 x 6 vent.

 

Reply to Alcove off fireplace - size of air vent? in the USA area at PlumbersForums.net

Similar plumbing topics

P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
316
Chuck
C
A
Emergency Stop Buttons in Boiler Rooms
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Replies
5
Views
243
oz-plumber
O
johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
240
exedon2
exedon2
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
184
dreikher
dreikher
M
Central heating losing pressure all the time
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
1
Views
113
fowlerboi
F
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock