ADVICE PLEASE MINIMUM CLEARANCE ON A COMBI FLUE

[ShaunCorbs]

So new system so no too bad then

 

[S.P.S.]

I was going to say, for a new system, that’s not bad. Don’t worry about the intergas boiler, you will be done with that

 

[Peter T]

It might be a fair price but If the job isn’t done with some care and attention the price is sadly irrelevant because the job isn’t done right. Thank you for your reassurance and posts
I am glad I started the thread today .

 

[Steve weightman]

The terminal of the flue is'ant 300mm from an opening

 

[Aire]

The terminal of the flue is'ant 300mm from an opening

Good point, there does look to be a clear hole which may lead into the property. Although further investigation would be required to know for sure. There may be an old wooden soffit board behind the upvc one.

 

[Steve weightman]

Good point, there does look to be a clear hole which may lead into the property. Although further investigation would be required to know for sure. There may be an old wooden soffit board behind the upvc one.

Yep ID

 

[Peter T]

Hello All
They are the original soffit boards and the fascia is wood covered on upvc cladding which was added later . I intend to replace the soffis and fascia with new upvc ones very soon.
Will this be ok.
Thanks
Peter

 

[ShaunCorbs]

Yep ID

Wrong

 

[ShaunCorbs]

Hello All
They are the original soffit boards and the fascia is wood covered on upvc cladding which was added later . I intend to replace the soffis and fascia with new upvc ones very soon.
Will this be ok.
Thanks
Peter

Yes just get them to use some silicon round the flue where they cut there upvc

 

[Peter T]

Hello Shaun
Thank you again for you very helpful advice.

Peter