1" GHT to 1" NPT needed. I need to find a plastic or PVC type fitting to jin together two pipes. The female is GHT, and the males side is NPT. I need to buy a bunch of them on an ongoing basis. Can anyone help me find them. No mass or metallic as they are cost prohibitive. Thanks!
Discuss 1" GHT thread (Female) to 1" NPT (Male) fittings needed Help! in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net
Reply to 1" GHT thread (Female) to 1" NPT (Male) fittings needed Help! in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net
Similar plumbing topics
Hello all,
I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one.
Granddaughter just moved house and this valve decided to leak when it was closed.
When open its fine.
Normally I have repacked the gland on...
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it 😬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
Cistern filling one third of the way
- Started by dwaindigital
- Replies: 2
-
Boiler losing pressure only on central heating- Started by SnosRap75
- Replies: 1
-
tanking. Is it ok to just seal everything with plastic.
- Started by Staggersandfalls
- Replies: 3
-
Pop quiz, does anyone recognise this radiator valve?
- Started by dimuc
- Replies: 3
-
SUsing coil to clear pipe leading to gutter
- Started by Sonya K
- Replies: 1
-
Replacing outdoor P-Trap Gully with Bottle Gully
- Started by DIwhYdidIstartThis
- Replies: 0
-
-
-
-
-
Mixer mixer shower, compatible with tanked supply
- Started by Matt0029
- Replies: 2
-
-
No Hot water, Fixed and Broken Again Ideal Logic 24
- Started by Filthbags
- Replies: 2
-
-
What's happening to this radiator, paint flaking off?
- Started by mikmikmikmik2024
- Replies: 3
