Grant Vortex 26 Combi No hot water

[algea100]

Hi have grant Vortex 26 Combi no hot water, have renewed dhw circulating pump and dhw pcb and sensor don't seem to have flow through heat exchanger any ideas?

 

[SimonG]

Expensive when you don't know what you are doing. Get a decent engineer out.

 

[Riley]

Not gas safe are you?

 

[Unregistered]

Expensive when you don't know what you are doing. Get a decent engineer out.

Thanks great help!!!!!!!!!!

 

[Unregistered]

Not gas safe are you?

No, Are You?!!!

 

[rpm]

Not gas safe are you?

Isn`t it an oil boiler?

 

[rpm]

Thanks great help!!!!!!!!!!

No, Are You?!!!

Be a good chap and put the toys back in the pram.

 

[Best]

No, Are You?!!!

Yellow badge below his name means he definitely is.
Nobody knows your background, but I assume you are just trying to repair your own boiler?
Your oil boiler work has already cost you a lot of expensive parts. Would be better to have got an engineer to do it. Unless you are a oil engineer and have an analyser etc?

 

[Riley]

You're correct rpm it is oil but all the same I've lost interest in the op as he's clearly not qualified to work on it

 

[rpm]

You're correct rpm it is oil but all the same I've lost interest in the op as he's clearly not qualified to work on it

I understand that.

 

[SimonG]

Thanks great help!!!!!!!!!!

Please log back in when replying to a thread. It could be any Tom, DICK, or Harriet.

As you obviously do not know what you are doing it is very good advice. From both a safety perspective and financially.

Have a great day.

 

[TVP&H Ltd]

Pop a location up....

 

[Dotty]

Watching this thread....

 

[lame plumber]

prehaps a more sympathetic approach is called for, and advise to use local oftec techie, who may be found on here. After all going on about being gas safe is a bit of a waste of time! reading the manual is a good starter for 10 and is what a techie normally does to find the first place to look. http://www.grantuk.com/wp-content/u...rvicing-instructions-DOC88-Rev00-May-2012.pdf then use someone who is good at fault finding and get them to service it once it is running again

 

[Dotty]

prehaps a more sympathetic approach is called for, and advise to use local oftec techie, who may be found on here. After all going on about being gas safe is a bit of a waste of time! reading the manual is a good starter for 10 and is what a techie normally does to find the first place to look. http://www.grantuk.com/wp-content/u...rvicing-instructions-DOC88-Rev00-May-2012.pdf then use someone who is good at fault finding and get them to service it once it is running again

Who are you and why are you on Lames account?

 

[lame plumber]

Who are you and why are you on Lames account?

been drinking that awful single malt you awld beggar

 

[Riley]

I did correct myself mate but the ops attitude turned me straight off