Search the forum,

Discuss Water Regulations approved booster Pumpset in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
C

Centralheatking

Got go and see a potential one Monday pm - I think its a grundfos - effort - bumps things up to
11/12 litres a min but is water regs legal -------- anybody know the name model make and
has anybody fitted them - are they any good. They boost up combis in low water pressure/volume areas
and steal the neighbours water .:behead:

centralheatking:wheelchair:
 
Fitted a home boost last week. Was rubbish, didn't work so had to take it back out.
 
I've just read and watched the video, was hoping to fit one on a property that wanted an unvented but only has 14 litres/ min flow, but it seems the home boost will only create 12/ l/min, so it's no good to me either.
 
You'll need an accumulator or a break tank, if its not viable to upgrade mains.
 
I think Grundfos do a package unit with breaktank and booster pump.

It's a black box if I remember. Never fitted one.

But have fitted much larger and they are very effective
 
I think Grundfos do a package unit with breaktank and booster pump.

It's a black box if I remember. Never fitted one.

But have fitted much larger and they are very effective

Have just checked this out, looks very favourable for my job.
 
even 12L is not good enough to have a combi ,
i am fitting a 100 gallon with a stuart turner Uneversal single impeller 3bar pump which will supply about 22L
I have done first stage of the job to remove old system and fit the combi temporary until they are ready for the rest of the work , I am just not sure should I run the cold feed to the pump in 28mm or should I do first few meters in 28mm and then go to 22mm , total distance from tank in the loft to pump in the ground floor is about 8m
 
But this is only going to give you like 11L , how is this any good ! Please explain

There's some terraced houses round my way all on a shared water supply, they only get a dribble first thing in the morning - they'd be well happy with 11lpm
 
Have looked at this situation on an economic front. I was going to install a break tank, pump and unvented cylinder. Did the maths and thought, hang about, I only need good pressure and flow for two showers and one bath, one of which is in the bath. Solution: two shower pumps off a conventional gravity HW cylinder £100 a piece. All the other outlets, I don't need massive pressure. The incoming main gives 1 bar at 9 litres pm.
 
if they only get a dribble that means some one is sucking it in big time ! and if 1 have a booster pump then the rest will have even less
 
Have looked at this situation on an economic front. I was going to install a break tank, pump and unvented cylinder. Did the maths and thought, hang about, I only need good pressure and flow for two showers and one bath, one of which is in the bath. Solution: two shower pumps off a conventional gravity HW cylinder £100 a piece. All the other outlets, I don't need massive pressure. The incoming main gives 1 bar at 9 litres pm.
that is a option where cylinder could be still used I agree !but combi on 9-12L is a big NO
 
Yes your right there; Combi's on low water pressure/flow are a pain:rockon2: Was not sure about these new booster pumps, as I thought this was against water regs; but if they are approved and work then fair play, will go with that:hurray:.
 
Status
Not open for further replies.

Reply to Water Regulations approved booster Pumpset in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
140
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
255
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
339
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock