Search the forum,

Discuss Worcester Greenstar 24Ri LPG boiler hot water ok but no central heating in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
D

digbyl123

Hello Folks , first time on here so be gentle !

Worcester Greenstar 24Ri LPG boiler

I have a conventional vented heating system with hot water cylinder in the airing cupboard . The whole system is 4 years old and runs on LPG . I have a salus pump , 3 port valve and control pack . The pump was replaced a year ago as although it seemed to work was not actually circulating any water ?
Everything was fine until 3 weeks ago , the central heating stopped working . The Hot water is working perfectly on the timer and the boiler comes on and goes off as it should . If I just pust the central heating on , or have it on timer the boiler seems to initialise but the green ignition light does not come on and it shuts down . The blue light does not flash to indicate a fault code . The room thermostate appears to operate ok and I changed the head on the 3 port valve as I have a spare . I have tested the 2 fuses on the PCB in the boiler and these are both OK

It seems the boiler isn't triggering the 3 port valve to go to port B ( C.H.) position

Could this be a fault with the PCB in the boiler ? Can you test the wiring to the 3 port valve from the boiler ?

Any help would be gratefully received , Thanks , Digs

\\
 
This plumbing forum will not provide advice to anybody with regards to boiler repairs or any other form of gas plumbing without you first providing us with your Gas Safe Registration number in a thread - for very obvious reasons. If you're not qualified to touch gas, you should stay well clear of trying to!
 
Status
Not open for further replies.

Reply to Worcester Greenstar 24Ri LPG boiler hot water ok but no central heating in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I have changed the 3 port actuator Honeywell head however this doesn’t seem to have solved the issue, does this mean that the programmer is faulty? Or is...
Replies
8
Views
294
Hi, I have a Worcester 28i junior boiler that has started to lose pressure, only when using the central heating. When using hot water I have no issue, however, when running the heating the pressure drops. Im looking for some ideas on what could be causing this. I have no sign of pipe leaks...
Replies
6
Views
148
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
140
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
232
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
2
Views
207
P
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock