Search the forum,

What make of tap

Post new thread

Discuss What make of tap in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
L

logiccircuits

Anyone any idea of the make of this tap. It needs new o-rings but there is no nut to undo to remove the spout and I don't know if the collar should undo but is seized. any help appreciated.
 

Attachments

  • IMG_9378.jpg
    IMG_9378.jpg
    85.9 KB · Views: 46
is there a screw at the back or do I see a nut at the bottom of the spout but just does have any flats, ie grips and a cloth/towel job or some posh rubber tipped ones
 
Tom Is right , the ring at the base can be unscrewed, it is the old version of the Bristan Sigma.
 
Status
Not open for further replies.

Reply to What make of tap in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
236
SimonG
SimonG
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
262
DIwhYdidIstartThis
D
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
176
Lou
Lou
W
Outdoor Tap at Porch
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
270
Dave Moore
D
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
398
Timmy D
T
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tiling Standards BS5389
Tiling News
DIY Forum
Tile Talk
Contractor Talk
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock