Unsafe situations

[mfgs]

You can still safety check it confirm its ok, just because the heating is running non stop doesn't make it unsafe if all other controls are good.

 

[Ermintrude]

As pcb is one unit. As pcb controls safety devices. The appliance has a defective damaged or inoperable safety device? ID !

 

[mfgs]

As pcb is one unit. As pcb controls safety devices. The appliance has a defective damaged or inoperable safety device? ID !

If all safety devices test ok (which should have been checked when working on the appliance), then there is no immediate danger. It is AR at best by your logic.

 

[Rickster123]

As pcb is one unit. As pcb controls safety devices. The appliance has a defective damaged or inoperable safety device? ID !

Its a faulty boiler you drama queen!

 

[Ermintrude]

Didn't say had checked if rather leave it off and repair the following day?

 

[dmheat]

They ID'd that?? ...did they follow unsafe sits and actually cap it I wonder?

 

[stevetheplumber]

if they have classed it id and not dissconected it the have failed in there duty riddor them for leaving an id appliance connected
in truth its a sales ploy

 

[kris]

Just because bg id it doesnt mean its actually an id situation. Ok the pcb has powetr to it having the heating on but that doesnt mean the that the safety devices dont work. Tbh they prob still function ok and its just a fault at the start of the board . But the fact theres power to the board would tell me the pcb might be ok and it could be the timer at fault. Possibly. As long as u do your duty by checkin all safety devices , flue, gas , stats etc and they all function correctly then it isnt at risk or immediate danger. The only thing the custard is in danger of is cooking to death lol. But if not sure isolate to relieve any worries and peace of mind.

 

[Reltub]

Mountain out of a mole hill springs to mind.

 

[Ermintrude]

Not really? Bit casual. If the CH contact stuck is the gas valve closed?