Search the forum,

Discuss Shower part suppliers in the Plumbing Jobs | The Job-board area at PlumbersForums.net

townfanjon

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
8,642
Guys , apart from showerdoc ( I never have any luck with them ) can anybody recommend any other shower part company's, one or two have been mentioned on here over the years . Thank you in advance.
 
I’ve tried about 5 different suppliers for enclosure spares and ended up going to the manufacturer despite their costs being exorbitant. I’ve found a lot of the after market stuff to be junk.
 
I’ve tried about 5 different suppliers for enclosure spares and ended up going to the manufacturer despite their costs being exorbitant. I’ve found a lot of the after market stuff to be junk.
Sorry should have said ,its valves etc .
Agree with the enclosure spares , waste of time unless its a recognised supplier
 

Reply to Shower part suppliers in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
158
Hi All I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Replies
0
Views
244
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
227
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
221
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
5
Views
499
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock