Discuss Replacing a 15mm Compression valve in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
A

Als dad

Hi I'm a new member looking for advice please, I am having to replace a 15mm isolation valve that has oliveson the one I am replacing, do I need to remove the old olives before fitting the new valve, and if so how should I do that without damaging the pipe, any help welcome.
 
As long as the existing olives haven't been tightened to buggery you should be fine.

Wrap a couple of turns of ptfe tape round the olives to ensure they don't leak.

If they do need changing then carefully use a junior hacksaw to cut through. A flat blade screwdriver can be used to open the olive up and slip it off.
 
If you are not removing the olives, then make sure the new valve pushes on until it hits each olive. A lot of those cheap slotted screw isolating valves have different distance in either end for pipe. The original olive might not pull closer if it had been tightened far too tight.
 
If you are not removing the olives, then make sure the new valve pushes on until it hits each olive. A lot of those cheap slotted screw isolating valves have different distance in either end for pipe. The original olive might not pull closer if it had been tightened far too tight.

Many thanks Best, appreciate your feedback.
 
Thanks for that! Could you thank Croppie as he is a very sensitive soul? :smile:

Don't want it now. Blokes marked his cards.

I'm going to edit all his future posts to infer that he enjoys getting intimate with goats.........
 
I'm going to edit all his future posts to infer that he enjoys getting intimate with goats.........

But not the ugly ones...
 
Status
Not open for further replies.

Reply to Replacing a 15mm Compression valve in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic...
Replies
2
Views
239
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about...
Replies
7
Views
265
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new...
Replies
1
Views
288
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is...
Replies
5
Views
564
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason...
Replies
3
Views
352
Back
Top