Radiator vents

Post new thread

Discuss Radiator vents in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
F

fredytedy

Hi are the standard size for Radiator vents 1/2" 1/4" or 1/8"? thanks
 
Last edited by a moderator:
Hi!

They can be any. On average though if they go in the end they are usually 1/2" in the top 1/4" or 1/8"
 
Status
Not open for further replies.

Reply to Radiator vents in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

B
What is correct toilet supply line
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic...
Replies
2
Views
235
ShaunCorbs
ShaunCorbs
Lou
Show us your fanciest radiators you have installed!!
Show us your fanciest radiators you've installed! We would love to see them! I love this Milano vertical radiator in the kitchen space. What...
Replies
4
Views
286
Timmy D
T
127bit
How to reinforce shower pan threshold?
The left rear floor corner is highest (the shower pan touches/sits on the floor), sloping down diagonally to the front right corner (lowest). The...
Replies
6
Views
272
127bit
127bit
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to...
Replies
6
Views
289
DIwhYdidIstartThis
D
W
Outdoor Tap at Porch
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended...
Replies
6
Views
304
Dave Moore
D

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock