Users can remove all display ads (not sponsors) for a small fee. Click for info (must be logged in)

New Starter From Manufacturing Industry

Post new thread

Discuss New Starter From Manufacturing Industry in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Hi Steve

Welcome to the forums,hope you enjoy,feel free to get involved

:):)
 
Status
Not open for further replies.

Reply to New Starter From Manufacturing Industry in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to...
Replies
6
Views
270
DIwhYdidIstartThis
D
Dan
  • Sticky
Australia Morning Thread
Morning to any Australians lurking around! Register its free, then message me, I'll sort your account out for you. We will need a moderator from...
Replies
0
Views
99
Dan
Dan
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
205
Lou
Lou
johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason...
Replies
3
Views
321
exedon2
exedon2
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new...
Replies
1
Views
249
SimonG
SimonG

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock