Discuss Measuring Hot Water Consumption in Shared Recirculation System in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Messages
1
Hello everyone,

I'm facing a rather complex situation and I need your expert advice. My neighbor and I share a boiler for hot water, and we have a single recirculation pump serving both of our homes. However, after the pump, the recirculation circuit splits into two separate branches, each serving our respective dwellings.

We currently have meters installed on the cold water to track individual consumption, but we lack a system to measure hot water usage. Our plumber claims that we cannot install meters on the hot water due to flow disturbances caused by recirculation.

I'm looking for a solution to fairly and accurately measure hot water consumption in each home. One idea I had considered was to install two meters, one at the entrance and one at the exit of the recirculation circuit, but I am aware of the technical difficulties this might entail.

I would like to know if, given the configuration of our system, a solution could be to install two separate recirculation pumps, one for each branch, and whether this could facilitate a more accurate measurement of individual consumption. Alternatively, are there flow meters or other technologies that can be effectively used in a system with these characteristics?

I would be very grateful for any advice, suggestions, or shared experiences you can offer.

Thank you very much for your time and attention to my request.

Best regards,
Lorenzo
 
I know there are such things as heat meters for communal hot water systems, eg in blocks of flats, but don't know anything about them.
My understanding is they measure flow, and also have two temperature probes, so can calculate energy extracted by measuring the difference between eg flow and return on hot water tank.
Might be worth researching?
 
Last edited:

Reply to Measuring Hot Water Consumption in Shared Recirculation System in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

All of my London house plumbing is being redone, with a heatpump heating a DHW tank, and a hot water recirculation system. With the hot water...
Replies
1
Views
368
Hello, We had an extension built seven years ago. Initially the builders' plumber connected the heating to the house system but this didn't work...
Replies
23
Views
831
I recently installed new hot and cold feeds to a new downstairs cloakroom. After refilling the system the hot taps were all dribbling, spluttering...
Replies
2
Views
550
Hi all, we have a water circulation pump to bring hot water from our woodburning stove and send it to a thermal accumulator tank. We've just...
Replies
3
Views
515
Hi all, new to this forum and looking for a bit of advice please. Have been noticing recently some odd behaviour with our hot water system. If...
Replies
13
Views
806
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock